MCP9808T-E/MS【PDF 16/52 页】IC TEMP SENSOR DGTL I2C 8MSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录44

12页 13页 14页 15页 [16页]17页 18页 19页 20页

MCP9808

DS25095A-page 16

?2011 Microchip Technology Inc.

5.1

Registers

The MCP9808 has several registers that are

user-accessible. These registers include the Tempera-

ture register, Configuration register, Temperature Alert

Upper Boundary and Lower Boundary Limit registers,

Critical Temperature Limit register, Manufacturer

Identification register and Device Identification register.

The Temperature register is read-only, used to access

the ambient temperature data. This register is double-

buffered and it is updated every t

CONV

. The Temperature

Alert Upper Boundary and Lower Boundary Limit

registers are read/write registers. If the ambient

temperature drifts beyond the user-specified limits, the

MCP9808 outputs a signal using the Alert pin (refer to

Section 5.2.3 Alert Output Configuration). In

addition, the Critical Temperature Limit register is used

to provide an additional critical temperature limit.

The Configuration register provides access to

configure the MCP9808 devices various features.

These registers are described in further detail in the

following sections.

The registers are accessed by sending a Register

Pointer to the MCP9808, using the serial interface. This

is an 8-bit write-only pointer. However, the four Least

Significant bits are used as pointers and all unused bits

(Register Pointer<7:4>) need to be cleared or set to 0.

each register.

W-0

Pointer bits

bit 7

bit 0

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as 0

-n = Value at POR

1 = Bit is set

0 = Bit is cleared

x = Bit is unknown

bit 7-4

W: Writable bits

Write 0.

Bits 7-4 must always be cleared or written to 0. This device has additional registers that are reserved

for test and calibration. If these registers are accessed, the device may not perform according to the

specification.

bit 3-0

Pointer bits

0000 = RFU, Reserved for Future Use (Read-Only register)

0001 = Configuration register (CONFIG)

0010 = Alert Temperature Upper Boundary Trip register (T

UPPER

)

0011 = Alert Temperature Lower Boundary Trip register (T

LOWER

)

0100 = Critical Temperature Trip register (T

CRIT

)

0101 = Temperature register (T

)

0110 = Manufacturer ID register

0111 = Device ID/Revision register

1000 = Resolution register

1xxx = Reserved

(1)

Note 1: Some registers contain calibration codes and should not be accessed.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式